Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: windows 2000 installation
PostPosted: Thu Aug 11, 2005 5:31 pm 
The past few days Ive been struggling to get the Xemacs
interface to singular 2.0.3 to work in Windows 2000. When I
first installed it,
I did get it to work once. However, I saw a message
in xemacs under the singular banner and above the command
line prompt that some package couldn't be found, so I
exited singular it and tried to
reinstall it or play with the environmental variables.
No luck. Then I tried uninstalling and reinstalling,
no luck. At this point, I can only get singular
running in a tshell (under cygwin) as administrator!
Ive read the previous posts on this topic but
either I don't understand them or they don't seem to help.

Any suggestions?

- David

PS: Im mostly interested in this because Id like to
adapt this interface to GAP, if possible. This seems
reasonable, since both are built on linux/unix machines
then ported to windows using cygwin.

email: wdj@usna.edu
Posted in old Singular Forum on: 2002-03-17 15:01:13+01


Report this post
Top
  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

It is currently Fri May 13, 2022 10:54 am
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group