Singular
https://www.singular.uni-kl.de/forum/

Memory usage
https://www.singular.uni-kl.de/forum/viewtopic.php?f=10&t=2858
Page 1 of 1

Author:  nbela1 [ Wed Jul 17, 2019 10:54 pm ]
Post subject:  Memory usage

I would like to know more about memory usage while Singular is executing a command (e.g. std).
As I understand, option(mem); would do.
When I switch on this option and start a computation, nothing happens (no [...k] in the output).
It is not sure that Singular is not killed before finishing a computation (e.g. out of memory).

Is there a special configure option to enable this option(mem) logging?
I had to compile and build Singular myself.
Thanks for any help in advance.

Author:  hannes [ Fri Jul 26, 2019 5:03 pm ]
Post subject:  Re: Memory usage

There is no special compile option for this:
it is a property of omalloc, so it is active unless --disable-omalloc
is given to configure.
You should also check the command memory:
https://www.singular.uni-kl.de/Manual/4 ... ng_295.htm

Author:  nbela1 [ Tue Jul 30, 2019 11:17 pm ]
Post subject:  Re: Memory usage

Thank you for your reply. Probably it was disabled somehow during compilation time.

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/